Sinclair ZX Spectrum Rebuild Kit – Issue 3 Boards
Complete set of parts to add a more reliable solid-state voltage regulator (original heatsink can then be removed, cutting down the heat inside the case), all electrolytic capacitors, DC power mod (for improved reliability in the DC power rectification circuit), ULA heatsink, and composite video mod (100uF capacitor).
Detailed instructions supplied, as well as an isopropyl wipe to clean the ULA before fitting heatsink.
Suitable for Issue 3 and 3B motherboards only – standard 48k rubber key or 48k plus cases.
£29.95 each
Free UK Shipping
Amiga A4000 RTC Repair Kit
A kit of components for A4000 systems that are affected by battery leak. These are the components that either break or the traces under them get corroded so they have to be swapped out.
This is what’s included:
1 x U177 (74HCT174)
1 x U178 (RP5C01 RTC Chip)
1 x U891 (74F245)
2 x U975,U976 (74HCT166)
2 x D177,D178 (N4148 Diode)
1 x RP176 (10k Resistor Network)
1 x Amiga Battery (CR2032 with holder)
1 x C192 (47uF Capacitor)
1 x 1N4148 Diode (Fitted to some boards only in place of N4148)
£34.95 each
Free UK Shipping
Atari Jaguar Repair Kit
The Atari Jaguar console is very prone to damage caused by accidentally using the incorrect power supply. This causes the two voltage regulators and sometimes an associated capacitor to fail. This kit contains all three parts to repair the console including a Nichicon low ESR capacitor to help prevent background noise on the audio output.
£17.95 each
Free UK Shipping
Sega Dreamcast Repair Kit
Full kit of components required to rebuild your Dreamcast controller PCB. This kit comprises a set of parts to replace the original battery with a new battery holder using the CR2032 coin cell, together with the parts required to convert the Dreamcast to be able to use the non-rechargeable battery safely. Also included is a replacement fuse to replace the original joystick fuse. The replacement is resettable, unlike the original. Should there be a joystick problem once the new fuse is fitted, disconnect joystick and the fuse will reset in approximately 4 or 5 seconds.
Also included with the kit is a replacement capacitor. This fails relatively rarely, but it’s good practice to replace while the console is dismantled.
Finally, I have included a number of replacement LEDs. Many users prefer a different colour LED to the original, and again it’s fairly easy to replace while the controller board is out of the case. The current kit includes Red, Green, Yellow, White, and Blue. Choose whichever colour you prefer.
Instructions supplied.
£7.95 each
Free UK Shipping
